How to Clean and Store ULTRASKYN Signature Strokers
By Doc Johnson | Official Store for Adult Toys, Enhancers & Lubes | Published: 2026-11-04
Category: Tips & Care
A step-by-step routine for cleaning, drying, powdering, and storing your ULTRASKYN Signature Stroker so the realistic texture lasts.
Quick answer
Rinse your ULTRASKYN Signature Stroker with warm water and mild soap after every use, dry it completely inside and out, then refresh the surface with a light dusting of renewing powder before storing it in a cool, dry place. Skip the powder and trapped moisture will make the material tacky and shorten its realistic feel.
Why ULTRASKYN needs a different routine than silicone
ULTRASKYN is a handcrafted, lifelike material designed to warm to the touch and mimic real skin, so it is softer and more porous than silicone. That realism is the reason it needs thorough drying and regular powder maintenance rather than a quick rinse and towel-off.
Because the Signature Strokers line is molded directly from a performer's body, the interior texture is deep and detailed. Those ridges hold moisture and residue, so a fast surface clean is not enough.
The trade-off: powder keeps it soft but needs consistency
A light dusting of renewing powder keeps the ULTRASKYN surface from becoming sticky and helps preserve that skin-like feel. The catch is that powder is not a one-time fix; it needs reapplying after cleaning and whenever the surface starts to feel tacky.
If you skip powder, the material can cling to itself and collect lint, which makes the stroker less pleasant to use and harder to clean next time.
What to avoid so you do not damage the material
Do not use alcohol, bleach, or harsh household cleaners on ULTRASKYN, and do not leave the stroker soaking in water. Also avoid storing it pressed against other toys or in a hot, sunny spot, because heat and contact can distort the soft material.
If your stroker has a hard outer case or optional sleeve, check the supplied care information for that specific component before cleaning, since not every part is meant to be submerged.
Step-by-step: clean, dry, powder, and store your Signature Stroker
- Rinse and wash with mild soap: Flush warm water through the interior, add a small amount of mild soap, and work it into the textured channel with your fingers. Rinse until the water runs clear. Common mistake: using hot water or harsh cleaners, which can degrade the soft ULTRASKYN surface.
- Shake out excess water: Shake the stroker gently over the sink to remove standing water from the interior before drying. Checkpoint: no water should pool at the bottom of the sleeve.
- Dry the interior completely: Wipe the inside with a clean, lint-free cloth or let it air-dry open-end down in a well-ventilated spot. Make sure the deepest part of the texture is dry before moving on. Common mistake: storing while damp, which encourages tackiness and odor.
- Dry the exterior: Pat the outside dry with a clean towel and let it finish air-drying. Checkpoint: the surface should feel dry, not slick or cool to the touch.
- Apply renewing powder lightly: Dust a small amount of renewing powder over the exterior and work it in with your fingers. Shake off any excess. Common mistake: over-powdering, which leaves a chalky residue; a thin layer is enough.
- Store in a cool, dry place: Place the stroker in its original packaging or a clean, breathable storage bag. Keep it away from heat, sunlight, and other toys that could press into the soft material. Checkpoint: store it unsealed enough to allow airflow, not in a damp drawer.
Product care notes
- Signature Strokers - Cory Chase - ULTRASKYN Pocket Pussy: Handcrafted in lifelike ULTRASKYN with a tight, textured interior that warms to the touch. The deep texture traps moisture and residue, so drying and powdering are not optional steps.
Signature Strokers - Cory Chase - ULTRASKYN Pocket Pussy
